Shop Categories

 [email protected]

3V0-41.19 VMware Advanced Design NSX-T Data Center 2.4 Exam Questions

Jul 10,2020

VMware 3V0-41.19 exam is known as a required test for VCAP-NV-Design-2020 certification. We have cracked the latest VMware Advanced Design NSX-T Data Center 2.4 3V0-41.19 real exam questions, which can make sure you pass the test. The VCAP-NV Design 2020 certification validates you can gather customer information, including requirements, risks, constraints, and assumptions, and use that information to make design recommendations for NSX-T Data Center solutions.

3V0-41.19 VMware Advanced Design NSX-T Data Center 2.4 Exam Questions

Learn VCAP-NV Design 2020 3V0-41.19 Exam

Learn the following VCAP-NV Design 2020 3V0-41.19 exam information, you can have a basic understanding of the VMware Advanced Design NSX-T Data Center 2.4 Exam.
Number of Questions: 50
Duration: 135 Minutes
Passing Score: 300
Format: Single and Multiple Choice, Proctored
Price: $450 USD

Study VMware 3V0-41.19 Exam Objectives

The following contents are covered in VMware Advanced Design NSX-T Data Center 2.4 3V0-41.19 exam objectives. 
Section 1–Architecture and Technologies
Section 2–Products and Solutions
Section 3–Planning and Designing
Section 4–Installing, Configuring, and Setup
Section 5–Performance-tuning, Optimization, and Upgrades
Section 6–Troubleshooting and Repairing
Section 7–Administrative and Operational Tasks

Share VMware Certification 3V0-41.19 Real Exam Questions

The new cracked VMware certification 3V0-41.19 real exam questions can help you test the above objectives. Share some VMware Advanced Design NSX-T Data Center 2.4 Exam 3V0-41.19 real exam questions and answers below.
1.Which two VMware recommendations should an architect follow when configuring top of rack (ToR) switches in an NSX-T Data Center environment? (Choose two.)
A. Modify the Spanning Tree Protocol to increase the time to transition to the forwarding state.
B. Configure redundant physical switches to enhance availability.
C. Use only IPv4 addressing in all deployments.
D. Configure switch ports that connect to ESXi host manually as trunk ports.
E. Configure switch ports with a Dynamic Trunking Protocol.
Answer: B,D

2.What would an architect recommend to a customer that wants to extend management to an additional data center through Layer 2, but does not want to add additional NSX-T licensing?
A. Deploy a standalone Edge as the L2 VPN client.
B. Deploy a standalone NSX Controller.
C. Deploy a standalone NSX Manager.
D. Deploy a standalone Edge as the IPSec VPN.
Answer: D

3.An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
This information was gathered during the assessment:
- There must be a performance based SLA for East - West traffic.
Which two key performance features should the architect recommend? (Choose two.)
A. Setup RSS to leverage multiple cores.
B. Enable GENEVE-Offload.
C. Configure N-VDS Enhanced Data Path.
D. Install advanced Edge pNIC Features.
E. Leverage DPDK drivers.
Answer: A,B

4.Which three are part of a Design Approach when discussing design alternatives and their effects. (Choose three.)
A. backup
B. knowledge
C. cost
D. security
E. budget
F. performance
Answer: C,D,F

Related Certificates

Related Exams