Search
Coatings Inspector Program Level 1 certification is so hot nowadays, which is designed for Coating Inspectors to validate the skills of performing and documenting basic and non-destructive inspections of liquid coatings applied by brush, roller or spray to steel surfaces. Coatings Inspector Program Level 1 certification is also a requirement for you to earn Coatings Inspector Program Level 2 or level 3 certification.
If you decide to earn Coatings Inspector Program Level 1 certification, you need to have the following knowledge points of Corrosion, Surface preparation, Cleanliness, Environmental conditions, Test instruments, Coating mixtures, Safety. Besides, you need to complete NACE CIP level 1 course on NACE official website, and then pass NACE-CIP1-001 exam.
To pass NACE-CIP1-001 exam, the following Coating Inspector Program Level 1 certification NACE-CIP1-001 exam information, topics and real exam questions are helpful in your preparation.
There are 100 questions in real Coating Inspector Program Level 1 certification NACE-CIP1-001 exam, and you have 2 and 1/2 hours to complete the test. NACE-CIP1-001 exam format is Computer Based Testing (CBT).
Coating Inspector Program Level 1 certification NACE-CIP1-001 exam topics cover the following 11 sections: Saftey(2.5%), Inspection Process(15%), Corrosion(5%), Environmental Controls and Inspection(5%), Surface Preparation and Inspection(20%), Coatings and Inspection(20%), Coating Application(7.5%), Documentation(10%), Standards(10%), Team Work(2.5%), Ethics(2.5%).
We have cracked the latest Coating Inspector Program Level 1 certification NACE-CIP1-001 real exam questions, which are helpful in your preparation. Share some NACE-CIP1-001 real exam questions below, you can read and study them.
1.Galvanic corrosion occurs on which of the following substrates:
A. Concrete
B. Fiberglass Reinforced Plastic
C. Metal
D. Wood
Answer: C
2.When applying Thermal Spray Coatings the specification is most likely to refence:
A. SSPC PA 2
B. NACE SP 0178
C. NACE SP 0188
D. SSPC-CS 23.00/AWS C2.23/NACE No. 12
Answer: D
3.What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?
A. 1 cm (.39 inch)
B. 2.5 cm (1 inch)
C. 6.35 cm (2.5 inch)
D. 2.5 millimeters (.10 inch)
Answer: B
4.Polymerization is the process of:
A. Monomers telegraphing
B. Monomers joining together
C. All thermoplastic coatings
D. All organic coatings
Answer: B
5.An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called
A. cracking.
B. sagging.
C. holiday.
D. checking.
Answer: C
The above information, topics and real exam questions can help you pass NACE-CIP1-001 exam successfully, and then you can earn Coating Inspector Program Level 1 certification.
