Shop Categories

 [email protected]

[NS0-192 Retired] New NCSE NS0-193 Exam Available

Aug 05,2019

NetApp Certified Support Engineer NS0-192 exam has been retired, and the new replacement test is NS0-193. Candidates for NetApp Certified Support Engineer (NCSE) certification should have at least 6 to 12 months of experience with NetApp solutions and technology, including on-site and remote support, general troubleshooting and root cause isolation, hardware replacement, documentation, node configuration, and software and firmware upgrades.

New NS0-193 Exam Questions Available | Replaces NS0-192

To earn Netapp Certified Support Engineer certification, you need to pass NS0-193 exam. The following NS0-193 exam information, topics and real exam questions are helpful in your preparation. 

NS0-193 Exam Information

There are 60 questions in real NS0-193 exam, and you have 1-1/2 hours to complete the test. In countries where English is not the native language, candidates for whom English is not their first language will be granted a 30-minute extension to the allotted examination completion time. You need to register Netapp certification NS0-193 exam at Pearson VUE test center. 

NS0-193 Exam Topics

NCSE ONTAP NS0-193 exam topics cover the following 5 sections. 

ONTAP Fundamentals

Platforms and Storage

Configuration and Troubleshooting

Performance Analysis

NetApp Data Protection and Management Software

NS0-193 Real Exam Questions

We have cracked the latest NS0-193 real exam questions, which are the latest version in the market. Our Netapp NS0-193 real exam questions are prepared by certified Netapp experts, who have collected all the latest NetApp Certified Support Engineer NS0-193 real exam questions. Share some NS0-193 real exam questions below. 
1.You are adding an additional node to a single-node cluster.Which of the actions should be performed after this upgrade? (Choose two.)
A. Verify that HA is enabled.
B. Verify that epsilon is not assigned.
C. Verify that epsilon is assigned.
D. Verify that HA is disabled.
Answer: C,D

2.Using QoS statistics for a group of volumes on one node, you notice that most of the latency comes from the data layer.In this scenario, which statement is correct?
A. There is too much indirect traffic from other nodes.
B. QoS processing is increasing CPU usage.
C. The CPU on the node is overused.
D. High disk use is increasing CPU usage.
Answer: D

3.A manager wants a volume to have a guaranteed 300 MB/s of read performance. You explain that you cannot do this on FAS storage running ONTAP 9.3 backed by 10,000 RPM disks.What is the reason for this response?
A. Throughput floors apply to only iSCSI access.
B. Throughput floors can only guarantee up to 125 MB/s.
C. Throughput floors require a license.
D. Throughput floors require AFF.
Answer: D

Use our NCSE NS0-192 real exam questions to clear the test successfully. 

Related Certificates

Related Exams