Shop Categories

 [email protected]

New JN0-334 will Replace JNCIS-SEC JN0-333 Exam

Sep 06,2019

Security, Specialist (JNCIS-SEC) JN0-333 exam will be retired on September 14, 2019, and the new replacement test is JN0-334. If you are preparing JN0-333 exam, please take it before September 14, 2019. This written JN0-333 exam verifies your understanding of security technologies and related platform configuration and troubleshooting skills. 

New JN0-634 will Replace JNCIS-SEC JN0-333 Exam

To prepare JN0-333 exam well, the following JN0-333 basic information, exam topics and real exam questions are helpful in your preparation. 

JN0-333 Exam Basic Information

In real Security, Specialist (JNCIS-SEC) JN0-333 exam, there are 65 Multiple-choice questions. Candidates have 90 minutes to complete the test. Register Juniper JN0-333 exam at Pearson VUE test center. After you complete Juniper certification JN0-333 exam, the pass/fail status is available immediately.

JN0-333 Exam Topics

Juniper JN0-333 exam topics cover all the following 7 sections.

JN0-333 exam topics

JN0-333 Real Exam Questions

The latest Juniper JN0-333 real exam questions contain 75 Q&As, which can help you test all the above exam topics. Share some Security, Specialist (JNCIS-SEC) JN0-333 real exam questions below. 
You recently configured an IPsec VPN between two SRX Series devices. You notice that the Phase1 negotiation succeeds and the Phase 2 negotiation fails.Which two configuration parameters should you verify are correct? (Choose two.)
A. Verify that the IKE gateway proposals on the initiator and responder are the same.
B. Verify that the VPN tunnel configuration references the correct IKE gateway.
C. Verify that the IKE initiator is configured for main mode.
D. Verify that the IPsec policy references the correct IKE proposals.
Answer: AB

In a chassis cluster, which two characteristics are true regarding reth interfaces? (Choose two.)
A. A reth interface inherits its failover properties from a redundancy group.
B. Reth interfaces must be the same type of interface.
C. Reth interfaces must be in the same slots on each node.
D. A reth interface goes down if one of its child interfaces become unavailable.
Answer: AB

The above JN0-333 exam information and related questions will be helpful in your JN0-333 exam preparation. If you want to take JN0-334 exam to earn JNCIS-SEC certification, you can read JN0-334 exam topics below.

Show JNCIS-SEC JN0-334 Exam Topics

Juniper JNCIS-SEC JN0-334 exam topics cover all the following topics, you can check the differences between JN0-333 and JN0-334 exam topics. 
JNCIS-SEC JN0-334 exam topics
We will crack the latest JN0-334 real exam questions soon, please pay more attention to the news on our website. 

Related Certificates

Related Exams